Name: CM4 Maker - Maker’s Carrier Board for Raspberry Pi CM4
SKU: 2913
Price: 1449.88 ZAR
Availability: InStock

CM4 Maker - Maker’s Carrier Board for Raspberry Pi CM4

3 available / new

Indicative market price: R1,594.87

Only 3 left – grab it before it’s gone!

R1,449.88

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

PiShop SA2403

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

2913

Bob Shop ID

613701221

Seeking for the ideal carrier board for your Raspberry Pi Compute Module 4 (CM4)? Introducing the CM4 Maker Board.

What is the Raspberry Pi Compute Module 4?

Compute Module 4 is officially launched on 19th October 2020, and there are 32 variants of the module to choose from.

The Raspberry Pi Compute Module 4 (CM4) and Compute Module 4 Lite (CM4Lite) are loosely based on the Raspberry Pi 4 Model B. The CM4 has an option for cost-sensitive applications to be supplied without the eMMC fitted; this version is called the CM4Lite. The form factor of the new CM4 and CM4L is different from previous Compute modules, which have all shared a form factor. The change is due to the addition of new interfaces; a second HDMI, PCIe, and Ethernet. The addition of these new interfaces, especially PCIe, would not have been possible while preserving the older form factor. Instead, the electrical interface of the CM4 is via two 100-pin high-density connectors. While the switch to a newer form factor has allowed a reduction in the footprint. The total footprint of the CM4, including the socket, is smaller with the new form factor design.

What's on the Board?

10x GPIO LED
1x microSD Card Slot
1x CSI Camera Port
1x DSI Display Port
5x Grove Ports
- 2x GPIO Ports (GPIO 5, 6 & 23, 24)
- 1x PWM Port (GPIO 12, 13)
- 1x UART Port (GPIO 14, 15)
- 1x I2C Port (GPIO 2, 3)
1x Maker Port (JST-SH 4-Ways Connector)
3x User Buttons
1x Analog Audio Out
1x Piezo Buzzer
1x Buzzer Mute Switch
2x Power Buttons
1x RTC Battery Holder