This item has closed with no items sold
View other items offered by Stax ZA0145

Similar products

Distance Ranging Time of Flight Module Sensor - VL53L1X
R191.76
9% OFF
WS GSM/GPRS/GNSS/Bluetooth HAT for Raspberry Pi
R698.95 R768.85
Waveshare D300 Developer Kit, DTOF Laser Ranging Sensor, 360 Omni-Directional Lidar, UART Bus
R1,964.00
Ic smd 8-ch i/o expander soic18 mcp23s08-e/so
R50.99
IQaudIO DigiAMP plus Pi-DigiAMP+ Raspberry Pi HAT - Works with Volumio & Home Assistant
Closed

IQaudIO DigiAMP plus Pi-DigiAMP+ Raspberry Pi HAT - Works with Volumio & Home Assistant

1 was available / secondhand
Indicative market price: R790.00
R590.00
25% off
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Get it now, pay later

Product details

Condition
Secondhand
Location
South Africa
Bob Shop ID
615854523

DigiAMP is a HAT compliant add on accessory for the Raspberry Pi. DigiAMP uses the Texas Instruments TAS5756M PowerDAC to deliver direct connection to PASSIVE stereo speakers at up to 2x35wpc with variable output. Ideal for a Pi based HiFi. DigiAMP can be connected to the Raspberry Pi A /B /RPi2/RPi3 or RPi4's 40way pin header without any additional soldering. DigiAMP must be powered from an external supply and requires a 1 2 to 24DC power source to
operate. DigiAMP s barrel connector is 5.5mmx2.5mm. DigiAMP has been designed to provide power to the Raspberry Pi and DigiAMP combination in parallel, delivering 5.1v 2.5Amp to the Pi.

DO NOT APPLY POWER TO THE RASPBERRY PIs OWN POWER INPUT WHEN USING DIGIAMP .

The amplifier is by default muted at power on (mute LED lit). The mute state LED is under software
control (Raspberry Pi GPIO22).


P5 Alternative power input for hard wired installations. POLARITY MUST BE OBSERVED!
P8 TAS5756m Internal GPIO1/2/3

Recently viewed

Nu Colour lash + brow serum
R950.00
Cyberpunk 2077 (PS4) – Complete
R499.00