Name: Nickel Spot Welder Handheld with Built-in 5V Rechargeable Lithium Battery Pack **LOCAL STOCK**
SKU: TTL193
Price: 729.00 ZAR
Availability: SoldOut

Nickel Spot Welder Handheld with Built-in 5V Rechargeable Lithium Battery Pack **LOCAL STOCK**

4 were available / new

R729.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Diy Select - Cape Town8393

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

TTL193

Bob Shop ID

611402563

Handheld Spot Welder 5V Rechargeable:

Specifications:

Charging Voltage: 5V DC (Higher than 5V will damage the unit)
Charging Current: 1/2A Max (5V 2A Charger Recommended)
Charging Port: Micro USB Charging Cable
This product supports charging while using

Features:

Handheld All-in-one
Built in 5V Rechargeable Battery Pack
Micro USB Charger Lead and Nickel strip Included
5 Gear Adjustable Power Display
4 Level Battery Display
Charging Indicator Light
Short press to turn on and cycle through power levels, Long press to turn off. 6 min of no use will auto power off

Instructions:

1. The battery should be fully charged, the thickness of the nickel sheet should not be thicker than 0.15mm. At full charge can do 0.2mm
2. Pay attention to the pressure when using the spot welder. The harder you press, the less heat, the lighter you press, the greater the heat. Pressing too light will cause perforation, too heavy and point not firm. So you need the right strength, do not press too hard.
3. The battery you weld on should be polished smooth, remove the surface of any oxide layer and ensure surface is even. Solder pen if oxidation black, please use fine sandpaper polished smooth.
4. Use the most pointed point of the pen. Soldering method: Visually see the welding tip, and the horizontal plane into 60 ° grip, two needles at the same time pressed in the nickel surface, good contact, current flows from one needle to the other needle, high current melting nickel for a good weld. Copper, aluminum surface can not be welded, rusty surface can not be welded, smooth stainless steel surface can be welded normally.